Bentel Omnia 4 Spécifications télécharger pdf (Page 26)

Fire sensors

To connect fire sensors to the Omnia8 burglar Control panel:

1. Program a Control panel Zone as a Normally Open 24h Zone.

2. Connect to the sensor repeat output.

Figure 15 shows the connection of three rate-of-rise temperature or smoke

detectors Bentel RT-101, RT-102, RF501t.

- The ground of the detector lines is powered by auxiliary output 24[O2].

This output must be programmed as Normally Closed, otherwise, it will

not supply the Fire GND signal (refer to "PROGRAMMING").

- A 100 mA max. current can circulate on terminal 24[O2].

Figure 16 shows the connection with line L1 as balanced and relay base.

Output 24[O2] as Normally Closed.

Figure 15 Connection of fire sensors

Figure 16 Connection with a balanced line and relay base

26 Security System Control Panels Omnia8/Omnia4

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 111 112

Pas de commentaire

Bentel Omnia 4 Spécifications Page 26