Bentel Omnia 4 Spécifications télécharger pdf (Page 34)

Typical installation

A diagram of a typical installation of the Omnia8 Control panel can be found in

the previous pages.

From left to right:

Ø Connection of the telephone line

Ø Connection of signalling devices ----indoor siren and self-powered siren

Ø Connection of three burglar sensors to line L1

Ø Connection of three fire sensors to line L8

Ø Connection of the Tamper line

Ø Connection of one Keypad and one Key reader to the BPI bus

Please note:

Ø Line L1 must be programmed as Balanced 10K as there is a 10 K balance

resistor.

Ø Line L8 must be programmed as Fire, and the auxiliary output (terminal

24[O2]) as Fire GND and Normally Closed.

The connections of the other Alarm lines are not shown, as burglar sen-

sors are connected as per line L1, and fire sensors are connected as per

line L8.

Use shielded cable with one end the connected to the Main Unit ground

and the other connected to the device ground.

34 Security System Control Panels Omnia8/Omnia4

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 111 112

Pas de commentaire

Bentel Omnia 4 Spécifications Page 34