Bentel Omnia 4 Spécifications télécharger pdf (Page 53)

Timer

The Control panel Timer controls Auto arming of partitions.

There are two different ways of programming partitions:

Weekly Different arming times each day.

Daily The same arming times every day.

30 minute Overtime requests can be made until midnight (24.00).

Overtime requests after midnight (24.00) will be ignored.

e.g. If the control panel is programmed to Auto arm at 23.45, and a 30 minute

Overtime request is made, the control panel will Auto arm at 24.00 i.e. the

Overtime request will be reduced to 15 minutes.

Figure 30 Timer page

PROGRAMMING 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 111 112

Pas de commentaire

Bentel Omnia 4 Spécifications Page 53